GSC Power-Division Billet Evo 1-3 and DSM S1 Camshafts
The GSC Power-Division billet S1 cams for the Mitsubishi DSM/EVO1-3 are designed for those with the stock turbo up to the GT30/50Trim. These cams will not sacrifice any bottom end loss over stock cams; nothing but gains and will promote faster spooling of the upgraded turbos. Gains of 30-55whp (depending on Turbo) have been seen by simply bolting the S1 cams in.
Warning:
This product can expose you to chemicals including Nickel (Metallic), which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm.
More information on California Proposion 65 can be found on Proposion 65 Warnings and OEHHA websites.
The GSC Power-Division billet S1 cams for the Mitsubishi DSM/EVO1-3 are designed for those with the stock turbo up to the GT30/50Trim. These cams will not sacrifice any bottom end loss over stock cams; nothing but gains, and will promote faster spooling of the upgraded turbos. Gains of 30-55 WHP (depending on turbo) have been seen by simply bolting the S1 cams in.
- Designed for a rev range of 3000-8000 RPMs
- 300-450 WHP camshaft
- Tapped for 98' DSM cam trigger
- Idle is slightly rougher than stock
- Upgraded valve spring recommended
- Made 100% in the USA
**If using aftermarket cam gears (especially AEM) check the bolt length. Some cam gears are too thick for the OEM bolt on the billet cams, a 40mm underhead length bolt may be necessary in this case**
7003S1 | ADV Duration | Duration @ 0.040" | Peak Lift | Center Line |
Intake | 268° | 216° | 11.00mm | 107° |
Exhaust | 268° | 220° | 10.50mm | 112° |