Evo 9 Camshafts

Products

GSC Power-Division Billet Evolution 9 Mivec Stroker R2 Camshafts
Part: GSC7009R2

The GSC Power-Division billet 7009R2 is designed to rev between 4000-8500 RPMs and should be used with a stroked engine or added displacement engine. The peak lift of 12.10mm intake and 12.00mm exhaust will require upgraded valve springs and a titanium retainer with special attention to seal to retainer clearance. With the lift of this profile, it is suggested to only use the 5041/5040 Ti retainer and spring kits due to valve seal to retainer clearance.

$725.00
 
(0 reviews)  
GSC Power-Division Billet Evolution 9 Mivec S1 Camshafts
Part: GSC7009S1

The GSC Power-Division billet S1 cams for the Mistubishi Evo 9 are designed for those with a stock turbo all the way to a GT30/50 trim. These cams will not sacrifice any bottom end loss over stock cams; nothing but gains, and will promote faster spooling of the upgraded turbos. Gains of 25-40 WHP (depending on turbo) have been seen by simply bolting the S1 cams in.

$725.00
 
(0 reviews)  
GSC Power-Division Billet Evolution 9 Mivec S2 Camshafts
Part: GSC7009S2

The GSC Power-Division billet 7009S2 cams for the Mitsubishi Evo 9 are designed for those with a goal of 400-700 WHP. No low end power is lost vs. the stock cams when used with the larger turbos. The S2 cams will show gains of 50-70 WHP over the stock cams, and in some cases more in the higher RPMs. Great for 2.0L engines with stock frame turbos revving to 9000 RPMs or for stroker motors revving to 8000 RPMs.

$725.00
 
(0 reviews)  
GSC Power-DivisionBillet Evolution 9 Mivec S3 Camshafts
Part: GSC7009S3

The GSC Power-Division billet 7009S3 cams are a hydraulic lifter profile for the Evo 9 4G63. These cams are meant for 700+ WHP to take advantage of a very large turbo. These are NOT suggested for anyone running smaller. 

$725.00
 
(0 reviews)