GSC Power-Division Billet Evolution 4-8 S1 Camshafts
The GSC Power-Division billet S1 cams for the Mitsubishi Evo 4-8 are designed for those with the stock turbo up to the 550 WHP stock location or aftermarket turbo kits. These cams will not sacrifice any bottom end loss over stock cams; nothing but gains, and will promote faster spooling of the upgraded turbos.
Warning:
This product can expose you to chemicals including Nickel (Metallic), which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm.
More information on California Proposion 65 can be found on Proposion 65 Warnings and OEHHA websites.
The GSC Power-Division billet S1 cams for the Mitsubishi Evo 4-8 are designed for those with the stock turbo up to the 550 WHP stock location or aftermarket turbo kits. These cams will not sacrifice any bottom end loss over stock cams; nothing but gains, and will promote faster spooling of the upgraded turbos. Gains of 30-55 WHP (depending on turbo) have been seen by simply bolting the S1 cams in.
- Designed for a rev range of 3000-7500 RPMs
- These cams work well on the stock valve springs with lower boost and RPM goals
- Idle is slightly rougher than stock
- Made 100% in the USA
**If using aftermarket cam gears (especially AEM) check the bolt length. Some cam gears are too thick for the OEM bolt on the billet cams, a 40mm underhead length bolt may be necessary in this case**
7008S1 | ADV Duration | Duration @ 0.040" | Peak Lift | Center Line |
Intake | 268° | 216° | 11.00mm | 107° |
Exhaust | 268° | 220° | 10.50mm | 113° |
Customers who viewed this product bought
-
GSC Power-Division Viton Valve Stem Seals for the Mitsubishi 4G63T
Part Number: GSC1002Out of stock