GSC Power-Division Beehive Spring Set with Titanium Retainer for all 4G63s
GSC Power-Division Beehive Spring Set with Titanium Retainer for all 4G63s
- IN: 100 lbs @ 1.539" / EX: 107 lbs @ 1.519" install height
- IN: 250 lbs @ 1.078" / EX: 256 lbs @ 1.058"
Check your valve spring install heights here
Warning:
This product can expose you to chemicals including Nickel (Metallic), which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm.
More information on California Proposion 65 can be found on Proposion 65 Warnings and OEHHA websites.
*Flip phone to landscape to see full table!*
| GSC5041 Beehive Valve Spring with Ti Retainers for all 4G63s | |||||
| Setup | Coil Bind (in) | Install Height (in) | Seat Pressure (lbs) | Open Pressure, 11.70mm Lift | Maximum Valve Lift (in) |
| Beehive | 1.004 | 1.539 / 1.519 | 100 / 107 | 250lbs @ 1.078" 256lbs @ 1.058" | 0.476 |
- Max RPM: 10,500 RPM
- Max boost: 44 psi
- Up to 12.1mm lift cams
The GSC Power-Division Beehive Valve Spring Kit with Ti retainer for all 4G63s includes 16 titanium retainers and 16 beehive valve springs. This kit is capable of 10,500 RPM with as much as 12.1mm lift cams (net valve lift max due to seal to bottom retainer contact). These are a must have for anyone pushing the limits. If you have had problems with valve float or throwing rocker arms, this is the spring set that will cure your problems for good. Our beehive spring utilizes advanced material heat treatment methods for superior load loss capabilities. These springs have the highest level of spring load retention while still maintaining good fatigue throughout the life of the spring. Beehive springs allow for the use of a smaller, lighter retainer allowing for higher RPM and more valve control.
